Blenheim Electric Inset Fire Manualist
Posted : admin On 18.01.2020
.Focal Point Fires plc. You are not permitted to copy or adapt any of the content without the prior written permission of Focal Point Fires plc. Remote control models: These appliances features a battery-operated control system, and under normal usage will need a new battery approximately every twelve months. Refer to the appropriate section of these instructions for details of how to change the battery. © 2013 Focal Point Fires plc.DEPTH should be 240mm or greater for a flue used for solid fuel of oil burning appliances. Opening DEPTHS include any plaster or infill panels which form part of the installation.
© 2013 Focal Point Fires plc.CLAY/CEMENT LINES OR BLOCK FLUE WHICH IS NEW, UNUSED, OR PREVIOUSLY ONLY USED WITH A GAS FIRE. X Dimension = 20mm UNLINED FLUE OR CHIMNEY WHICH HAS BEEN PREVIOUSLY USED FOR A SOLID FUEL OR OIL BURNING APPLIANCE X Dimension = 60mm © 2013 Focal Point Fires plc.Self tapping screw pack; 4 No.8 x 5/16 Spigot restrictor Deflector baffle Set of manufacturers instructions Slide control position marking sticker (slide control models only) Slide control knob and M4 Nyloc nut (slide control models only) © 2013 Focal Point Fires plc.8mm sup- ply pipe should be temporarily sealed to prevent the ingress of debris during fixing. PLEASE NOTE: Ensure fire can be removed for ease of servicing and not silconed © 2013 Focal Point Fires plc.Now disconnect the inlet restrictor elbow from the inlet pipe. Connect the previously installed gas supply to inlet restrictor elbow, and re-fit the restrictor elbow to the inlet pipe of the appliance.
Blenheim Electric Inset Fire Manualist Pictures
Figure 10 © 2013 Focal Point Fires plc. FIN.Continue pressing down the knob while turning further to the left to activate the piezo spark, continue to hold the knob down for a further 10 seconds after the pilot has been lit.
If the pilot does not light repeat the previous steps. © 2013 Focal Point Fires plc.MUST be of a type supplied for the purpose by the appliance manufacturer. If the fire is not spilling, then further guidance should be sought, using the Troubleshooting section as a guide. © 2013 Focal Point Fires plc.15. Check any purpose provided ventilation is un-obstructed.
Blenheim Electric Inset Fire Manualist 2017
Light the fire and test for spillage. Check the operating pressure (see section 16.5) and safe operation of the appliance. For specific servicing instructions, see the relevant sections. © 2013 Focal Point Fires plc.Ensure appliance is off and cool.
The battery is located in the front of the ignition unit, on the right hand side of the burner (shown in figure 8). Unscrew the battery holder cap. Insert 1 x ‘AA’ (1.5 volt) battery. Figure 21 © 2013 Focal Point Fires plc. Spillage occurring. Carry out Spillage test and rectify any problems. Combustible materials used in incorrect positions.
Firebox grommet seal missing, rectify. Other airborne contaminants such as dust, tobacco smoke, paint vapours.
© 2013 Focal Point Fires plc.100mm of either side of the fireplace opening, providing the forward projection does not exceed 100mm. Any combustible side walls must be at least 500mm to the side of the radiant heat source.
As with all heating appliances, any decorations, soft © 2013 Focal Point Fires plc.HIGH or LOW positions, press the control knob in, and return to the nine o’clock position and release.To turn the fire OFF, keep the knob pressed in, return to the off position and release. © 2013 Focal Point Fires plc.Switch the appliance OFF, call in your installer to check any ventilation and carry out any remedial work required. DO NOT allow the appliance to be used until the installation is passed as safe. © 2013 Focal Point Fires plc.Place the large brick panel against the rear of the firebox. Figure 12 Place the ceramic combustion matrix onto the burner and the ceramic side cheeks onto the matrix.
© 2013 Focal Point Fires plc.Figure 18 Place the middle row of four coals onto the supports in the matrix, over the top of the holes. Ensure the coals are not turned sideways, such that they actually enter the holes. © 2013 Focal Point Fires plc.Ensure appliance is off and cool.
The battery is located in the front of the ignition unit, on the right hand side of the burner (shown in figure 8). Unscrew the battery holder cap. Insert 1 x ‘AA’ (1.5 volt) battery. Figure 21 © 2013 Focal Point Fires plc.Remote handset and receiver kit F730003/5 12.0 INSTALLATION DETAILS Name & contact details of installer: Supplied by: Installer GAS SAFE registration No: Model: Fire serial No.: Date installed: © 2013 Focal Point Fires plc.3G Service Department to the address below.
Alternatively, you can email or fax.Please note that this does not affect your statutory rights. Focal Point Fires plc, 3G Service Department, Reid Street, Christchurch, Dorset, BH23 2BT.
Alternatively email: 3g@focalpointfires.co.uk or fax. Tekken 6 for pc free download full version rar.